Industrial Managed Ethernet Switch

Physical Port

16 10/100/1000BASE-T Gigabit Ethernet RJ45 ports with IEEE 802.3at PoE+ Injector2 10/100/1000BASE-T Gigabit Ethernet RJ45 ports2 100/1000BASE-X mini-GBIC/SFP slots for SFP type auto detectionOne RJ45 console interface for basic management and setup

Power over Ethernet

- Total PoE power budget control- Per port PoE function enable/disable- PoE admin-mode control- PoE port power feeding priority- Per PoE port power limit- PD classification detection- Temperature threshold control- PoE usage threshold control- PD alive check- PoE scheduleComplies with IEEE 802.3at Power over Ethernet Plus/end-span PSEUp to 16 IEEE 802.3af/802.3at devices poweredSupports PoE power up to 36 watts for each PoE portAuto detects powered device (PD)Circuit protection prevents power interference between portsRemote power feeding up to 100mPoE management featuresIntelligent PoE features

Industrial Case & Installation

IP30 aluminum case protectionDIN rail and wall-mount design48~56V DC, redundant power with polarity reverse protect functionSupports 6000V DC Ethernet ESD protection-40 to 75 degrees C operating temperature

Digital Input & Digital Output

2 Digital Input (DI)2 Digital Output (DO)Integrate sensors into auto alarm systemTransfer alarm to IP network via email and SNMP trap

Layer 2 Features

- Broadcast/Multicast/Unicast- IEEE 802.1Q tagged VLAN- Up to 255 VLANs groups, out of 4094 VLAN IDs- Provider Bridging (VLAN Q-in-Q) support (IEEE 802.1ad)- Private VLAN Edge (PVE)- Protocol-based VLAN- MAC-based VLAN- Voice VLAN- IEEE 802.1D Spanning Tree Protocol (STP)- IEEE 802.1w Rapid Spanning Tree Protocol (RSTP)- IEEE 802.1s Multiple Spanning Tree Protocol (MSTP), spanning tree by VLAN- BPDU Guard- 802.3ad Link Aggregation Control Protocol (LACP)- Cisco ether-channel (static trunk)- Maximum 10 trunk groups with 4 ports per trunk group- Up to 8Gbps bandwidth (duplex mode)Prevents packet loss with back pressure (half-duplex) and IEEE 802.3x pause frame flow control (full-duplex)High performance of Store-and-Forward architecture, and runt/CRC filtering eliminates erroneous packets to optimize the network bandwidthStorm Control supportSupports VLANSupports Spanning Tree ProtocolSupports Link AggregationProvides port mirror (1-to-1)Port mirroring to monitor the incoming or outgoing traffic on a particular portLoop protection to avoid broadcast loopsSupports ERPS (Ethernet Ring Protection Switching)

Layer 3 IP Routing Features

Supports maximum 32 software static routes and route summarization

Quality of Service

- IEEE 802.1p CoS- IP TOS/DSCP/IP precedence- IP TCP/UDP port number- Typical network applicationIngress Shaper and Egress Rate Limit per port bandwidth control8 priority queues on all switch portsTraffic classificationStrict priority and Weighted Round Robin (WRR) CoS policiesSupports QoS and In/Out bandwidth control on each portTraffic-policing policies on the switch portDSCP remarking

Multicast

Supports IGMP snooping v1, v2 and v3Supports MLD snooping v1 and v2Querier mode supportIGMP snooping port filteringMLD snooping port filteringMVR (Multicast VLAN Registration)

Security

IEEE 802.1x Port-based/MAC-based network access authenticationBuilt-in RADIUS client to cooperate with the RADIUS serversTACACS+ login users access authenticationRADIUS/TACACS+ users access authenticationIP-based Access Control List (ACL)MAC-based Access Control ListSource MAC/IP address bindingDHCP snooping to filter distrusted DHCP messagesDynamic ARP Inspection discards ARP packets with invalid MAC address to IP address bindingIP Source Guard prevents IP spoofing attacksIP address access management to prevent unauthorized intruder

Management

- Console/Telnet Command Line Interface- Web switch management- SNMP v1 and v2c switch management- SSH/SSL and SNMP v3 secure accessSwitch Management InterfacesFour RMON groups (history, statistics, alarms, and events)IPv6 IP address/NTP/DNS managementBuilt-in Trivial File Transfer Protocol (TFTP) clientBOOTP and DHCP for IP address assignmentFirmware upload/download via HTTP/TFTPDHCP RelayDHCP Option 82User Privilege levels controlNetwork Time Protocol (NTP)Link Layer Discovery Protocol (LLDP)SFP-DDM (Digital Diagnostic Monitor)Cable diagnostic technology provides the mechanism to detect and report potential cabling issuesReset button for system reboot or reset to factory defaultPLANET Smart Discovery Utility for deployment management

Hardware SpecificationsCopper Ports18 10/100/1000BASE-T RJ45 auto-MDI/MDI-X portsSFP/mini-GBIC Slots2 1000BASE-SX/LX/BX SFP interfaces (Port-19 and Port-20)
Compatible with 100BASE-FX SFPPoE Injector Port16 ports with 802.3at/af PoE injector function with Port-1 to Port-16Console1 x RJ45-to-RS232 serial port (115200, 8, N, 1)Switch ArchitectureStore-and-ForwardSwitch Fabric40Gbps/non-blockingThroughput (packet per second)29.7Mpps@ 64Bytes packetAddress Table8K entries, automatic source address learning and agingShared Data Buffer4MbitsFlow ControlIEEE 802.3x pause frame for full-duplex
Back pressure for half-duplexJumbo Frame9KbytesReset Button< 5 sec: System reboot
> 5 sec: Factory defaultESD Protection6KV DCEnclosureIP30 aluminum caseInstallationDIN rail kit and wall-mount kitConnectorRemovable 6-pin terminal block for power input
Pin 1/2 for Power 1, Pin 3/4 for fault alarm, Pin 5/6 for Power 2
Removable 6-pin terminal block for DI/DO interface
Pin 1/2 for DI 1 & 2, Pin 3/4 for DO 1 & 2, Pin 5/6 for GNDAlarmOne relay output for power failure. Alarm Relay current carry ability: 1A @ DC 24VDI/DO2 Digital Input (DI):
Level 0: -24V~2.1V (±0.1V)
Level 1: 2.1V~24V (±0.1V)
Input Load to 24V DC, 10mA max.
2 Digital Output (DO): Open collector to 24V DC, 100mA max.LED IndicatorSystem:
Power 1 (Green)
Power 2 (Green)
Fault Alarm (Green)
Ring (Green)
Ring Owner (Green)
Per 10/100/1000T RJ45 PoE+ Ports:
PoE-in-Use (Orange)
LNK/ACT (Green)
Per 10/100/1000T RJ45Ports:
1000 LNK/ACT (Orange)
100 LNK/ACT (Green)
Per SFP Interface:
1000 LNK/ACT (Orange)
100 LNK/ACT (Green)Dimensions (W x D x H)152 x 107x 84 mmWeight1533gPower RequirementsDual 48~56V DC (>51V DC for PoE+ output recommended)Power Consumption11.1 watts/37.87BTU (Power on without any connection)
349 watts/119.08BTU (Full loading with PoE function)Power Over EthernetPoE StandardIEEE 802.3at Power over Ethernet Plus/PSEPoE Power Supply TypeEnd-spanPoE Power OutputIEEE 802.3af Standard
- Per port 48V~51V DC (depending on the power supply), max. 15.4 watts

IEEE 802.3at Standard
- Per port 51V~56V DC (depending on the power supply), max. 36 wattsPower Pin Assignment1/2(+), 3/6(-)PoE Power Budget48V Power input
- 240W maximum (depending on power input)

56V Power input
- Single power input: 260W maximum (depending on power input)
- Dual power input: 320W maximum (depending on power input)Max. number of Class 2 PDs16Max. number of Class 3 PDs16Max. number of Class 4 PDs10Layer 2 FunctionBasic Management InterfacesConsole; Telnet; Web browser; SNMP v1, v2cSecure Management InterfacesSSH, SSL, SNMP v3Port ConfigurationPort disable/enable
Auto-negotiation 10/100/1000Mbps full and half duplex mode selection
Flow control disable/enable
Power saving mode controlPort StatusDisplay each port’s speed duplex mode, link status, flow control status,
auto negotiation status, trunk statusPort MirroringTX/RX/both
1 to 1 monitorVLAN802.1Q tagged based VLAN, up to 255 VLAN groups
Q-in-Q tunneling
Private VLAN Edge (PVE)
MAC-based VLAN
Protocol-based VLAN
Voice VLAN
MVR (Multicast VLAN Registration)
Up to 255 VLAN groups, out of 4094 VLAN IDsLink AggregationIEEE 802.3ad LACP/static trunk
Supports 10 trunk groups with 4 ports per trunk groupQoSTraffic classification based, strict priority and WRR
8-level priority for switching
- Port number
- 802.1p priority
- 802.1Q VLAN tag
- DSCP/TOS field in IP packetIGMP SnoopingIGMP (v1/v2/V3) snooping, up to 255 multicast groups
IGMP querier mode supportMLD SnoopingMLD (v1/v2) snooping, up to 255 multicast groups
MLD querier mode supportAccess Control ListIP-based ACL/MAC-based ACL
Up to 123 entriesBandwidth ControlPer port bandwidth control
Ingress: 500Kb~1000Mbps
Egress: 500Kb~1000MbpsSNMP MIBsRFC-1213 MIB-II
IF-MIB
RFC-1493 Bridge MIB
RFC-1643 Ethernet MIB
RFC-2863 Interface MIB
RFC-2665 Ether-Like MIB
RFC-2819 RMON MIB (Group 1, 2, 3 and 9)
RFC-2737 Entity MIB
RFC-2618 RADIUS Client MIB
RFC-2933 IGMP-STD-MIB
RFC3411 SNMP-Frameworks-MIB
IEEE 802.1X PAE
LLDP
MAU-MIBLayer 3 FunctionIP InterfacesMax. 8 VLAN interfacesRouting TableMax. 32 routing entriesRouting ProtocolsIPv4 software static routing
IPv6 software static routingStandards ConformanceRegulatory ComplianceFCC Part 15 Class A, CEStability TestingIEC60068-2-32 (free fall)
IEC60068-2-27 (shock)
IEC60068-2-6 (vibration)Standards ComplianceIEEE 802.3 10BASE-T
IEEE 802.3u 100BASE-TX/100BASE-FX
IEEE 802.3z Gigabit SX/LX
IEEE 802.3ab Gigabit 1000T
IEEE 802.3x flow control and back pressure
IEEE 802.3ad port trunk with LACP
IEEE 802.1D Spanning Tree Protocol
IEEE 802.1w Rapid Spanning Tree Protocol
IEEE 802.1s Multiple Spanning Tree Protocol
IEEE 802.1p Class of Service
IEEE 802.1Q VLAN tagging
IEEE 802.1x Port Authentication Network Control
IEEE 802.1ab LLDP
IEEE 802.3af Power over Ethernet
IEEE 802.3at Power over Ethernet
RFC 768 UDP
RFC 793 TFTP
RFC 791 IP
RFC 792 ICMP
RFC 2068 HTTP
RFC 1112 IGMP v1
RFC 2236 IGMP v2EnvironmentOperating Temperature-40 ~ 75 degrees CStorage Temperature-40 ~ 85 degrees CHumidity5 ~ 95% (non-condensing)